《采油工程(含课程设计)》第二次在线作业(国外英文资料).docVIP

《采油工程(含课程设计)》第二次在线作业(国外英文资料) The first oil pump is a quick and reciprocating motion of turning the motors high-speed rotating motion into a sucker rod Your answer: wrong Topic score: 0.5 Score: 0.5 Note: slow motion Both the chain and belt pumping units belong to the unswam beam pumping unit Your answer: correct Topic score: 0.5 Score: 0.5 Note: no swimming beam The pump is better than the bar pump for the convenience of the inspection pump Your answer: wrong Topic score: 0.5 Score: 0.5 Note: bar pump is better than pipe pump The fourth problem is that the barrel pump is better than the pipe pump Your answer: wrong Topic score: 0.5 Score: 0.5 Note: pipe pump is better than rod pump Submergence is the relative height of the suction valve of the pump and the level of the hydrostatic surface Your answer: wrong Topic score: 0.5 Score: 0.5 Note: the relative height of the moving fluid The stop valve is open during the stroke and the stationary valve is closed Your answer: wrong Topic score: 0.5 Score: 0.5 Note: to fully understand how the pump works The fluid column loads are applied to the tubing during the stroke of the stroke Your answer: correct Topic score: 0.5 Score: 0.5 Note: to understand the load on the suspension points In the 8th, the motion of the suspension of the oil pump can be reduced to the simple harmonic motion Your answer: correct Topic score: 0.5 Score: 0.5 Note: the suspension movement simplifies the analysis Problem number 9 is the highest acceleration in the stroke and the direction up Your answer: wrong Topic score: 0.5 Score: 0.5 Note: direction down The submergence of the stroke in question 10 has no effect on the suspension load Your answer: wrong Topic score: 0.5 Score: 0.5 Note: the effect is motivation At the bottom of the well head, the load is reduced by the drop of the rod Your answer: correct Topic score: 0.5 Score: 0.5 Remark: correct The maximum load occurred in the upper stroke Your answer: correct Topic score: 0.5 Score: 0.5 Note: