发电机容量之选择常识 (阅170)(国外英文资料).docVIP

发电机容量之选择常识 (阅170)(国外英文资料) General knowledge of generator capacity (see 170) -- -- -- -- - The basic principle of The 2.1 generator capacity shall first meet the need for steady computing load, which includes both the fire load and the guaranteed load. In civil buildings, diesel generators are set up, usually first as a backup power supply for fire power equipment. A power failure in the city, or the interlock, opens the generator set. But the probability of an electric power failure is much higher than the probability of a fire, and it does not mean that the fire is happening. Of fire, open the generator set only burden of emergency lighting and other small load, if the other not important fire load (with three kinds of load, the life of the pump, passenger elevator, skirt building lighting, etc., known as guarantee load) care, will cause the unit vacant, waste of resources. Therefore, the design of low-voltage distribution system diagram, on the premise of satisfying the needs of the fire fire load, must also consider a power outage rather than fire, generator to ensure power supply in the load. One way to do this is to ensure that the load concentration is attached to the generator emergency bus segment, and the fire signal will ensure that the total switching of the load is shunt. In short, we should fire load and guarantee load are calculated respectively, in both large values as the basis of determine the generator unit capacity, and at the same time meet the corresponding requirement of the fire department and the project owner. How to calculate fire load correctly should be taken seriously. Large and medium-sized civil buildings, often consisting of basements, skirts and towers, contain multiple fire zones. When determining the capacity of generator and the calculation of fire load, it is obvious that all fire and power equipment should not be accounted for blindly. The recommended calculation principle is only considered a fire compartment fire (like fire),