变电运行51~100(国外英文资料).docVIP

变电运行51~100(国外英文资料) Why does the battery self-discharge? Answer: the main reason for the battery self-discharge is due to the plate containing impurities, the formation of local small batteries, and small batteries poles of the short circuit loop, cause the battery self-discharge. In addition, due to different density of battery electrolyte, the electromotive force of the pad is not equal, which can also cause the batterys self-discharge. Why do you charge and discharge batteries regularly? Answer: regularly check the charge and discharge, also called to charge and discharge is on operation of float charging battery, after a certain time to make the plate material on a larger charge and discharge reaction, in order to check the battery capacity, and can be found in aged cells, timely maintenance process, in order to ensure the normal operation of the battery, charge and discharge is usually not less than once a year on a regular basis. 53, the traffic light and the dc power monitoring lamp why should connect a resistance? A: the purpose of the traffic light resistance is to prevent the socket from being turned on and off by the switch. Dc power supply monitor lamp series a resistor purpose is to prevent the filament or lamp holder short by shorting dc power supply and power supply to prevent the high voltage dc power supply monitor lamp burn out. How is the load ratio calculated? Answer: the load ratio = (the maximum value of the daily load curve) * 100% Why do 1, 10kv and the above transformer have to ground the neutral point before the power failure and transmission? A: the 110KV power grid in our country generally adopts the neutral point direct grounding system. In the operation, some transformers have neutral neutral operation to meet the sensitivity of the relay protection device. But because of the circuit breaker at the same time the operating overvoltage caused by endangering the transformer insulation, so the requirement in relevant to 110 kv and above no-l