变频器TD1000参数表(国外英文资料).docVIP

变频器TD1000参数表(国外英文资料) Chapter v function parameter list 26 F000 run frequency Settings range: 0 ~ 9 Digital Settings for 0:1 Set the run frequency by the F001 code direct number (also available in the run Touch panel Sunday afternoon, ∨ keys to change, but the frequency of the modified values It is not immediately stored in F001, only to control the power off (Poff) is automatically stored in F001. Digital Settings for 1:2 The initial frequency is zero frequency, and the control terminal is available in operation UP/DOWN - COM breaks DOWN to change the running frequency. After the STOP It runs at zero frequency. After the Poff, the modified frequency value does not exist Storage in F001. 2: simulate voltage terminal (vci-gnd) setting, input voltage norm Circumference: DC: 0 ~ 10 v. 3: the voltage/current loss of the analog current/voltage terminal (CCI - GND) Setting, range: 4 ~ 20mA/DC: 0 ~ 10V (short circuit block Switch). 4: use the above computer serial communication setting Digital Settings for 5:3 The F001 direct digital frequency setting is available during the run/stop process With touch panel Sunday afternoon and ∨ key to change, but dont modify the code F001 Content, not stored at Poff. Digital Settings for 6:4 The initial frequency is zero frequency, and the external control terminal is available during the run UP/DOWN - COM breaks DOWN to set the running frequency, but STOP and then keep the frequency before STOP. 7: the operating panel frequency sets the potentiometer setting. Potentiometer setting Indicator) 8: VCI + CCI set Frequency Settings are set by VCI and CCI. 9: VCI - set the CCI Frequency Settings are set by the difference between VCI and CCI. VCI + (CCI - 5V / 10mA) set The frequency is set by VCI and CCI and can be achieved by 5V or 10 ma bias. ?? Description: The control must be controlled when selecting the ccci for the voltage/current input Select the jump line of the voltage/current select plug-in CN10 on the board When choosing voltage i