变频器常见故障代码及处理实例_(国外英文资料).docVIP

变频器常见故障代码及处理实例_(国外英文资料) The primary loop trip This fault show the operation process of converter has big noise (commonly known as shooting), or to send electricity when the phone is switched on, the inverter control circuit breaker or switch trip air. This is usually due to the main circuit (including rectifier module, electrolytic or inverter bridge) breakdown caused by short circuit, direct at the instant of the breakdown of intense current noise module burst caused enormous. The reason for the damage of the module is multi-faceted, not very general. Only a few of these are listed. 1, the damage of the rectifier module is largely due to the pollution of the power grid. For controlled rectifier used in the inverter control circuit, such as thyristor welding machine, locomotive charging bottles, etc.), make the power grid waveform is no longer a rule of sine wave, make rectifier module by the power grid pollution and damage, the need to enhance the absorptive capacity of inverter power supply at the input. The circuit is also designed within the converter. But as the pollution levels of the grid increase, the circuit should also be improved to increase the capacity to absorb the peak voltage of the grid. The damage of electrolytic capacitors and IGBT is mainly due to uneven pressure, which includes both dynamic and static pressure. In the use of the daily converter, due to the reduced capacity of some capacitors, the differential pressure of the whole capacitor group, the capacitance of the Shared voltage must be blown apart. IGBTs damage is due mainly to the overvoltage of the mother line and the insufficient absorption of the buffer circuit. In the process of IGBT turn-on and turn-off, has the extremely high current rate of change, when the bus design is unreasonable, cause busbar high inductance, which can make module for high voltage and breakdown, the breakdown of the instantaneous large current caused burst module and so reduce the busbar inductance is the key