导轮安装方法(国外英文资料).docVIP

导轮安装方法(国外英文资料) Roller maintenance Guide roller and roller bearing is the key to the wire-cut machine parts, good accuracy, good finish, high efficiency relies on a pair of balance, light and accurate guide wheel. The maintenance of the steering wheel and bearing shall begin from the installation, and the tools and assembly environment shall be clean and shall not be carried in the bearing position. Put an end to all the tight installation, are not allowed to break the whole process and pressure distribution, deformation caused by such installation will completely destroy the idler pulley and bearing of the original precision. Take special note of guide roller in use, when a foreign body bearing rotating inflexible or jam idler pulley, wire in the v-shaped grooves to do le, instantaneous V groove shape accuracy is lost. The bearing work environment is not to be put into sewage, and the impurities are very fast. What is more remarkable is that the bearings and the steering wheel must not allow the current to flow, and if the high-frequency power supply is used as a channel, the instantaneous corrosion is very serious. Dirty water, especially the dirty water cut aluminum, should be replaced in time. A machine tool that has been operating for several decades must wipe the root of the guide and the bearing sleeve to remove the filling. Add a small amount of oil, and let the silk run at full speed for a few minutes, then pour the oil into the oil and throw it in the oil. The assembly is reasonable, use proper, maintain the effective one pays the guide wheel, usually should be able to make 2 ~ 3 years, a bearing should also be able to make more than half a year. Should pay attention to is currently on the market for the quality of the bearing is very worrying, inner and outer rings of radial runout and axial clearance and wearability of bead and ballistic is not credible, though its packaging and tags are not apparent, or choose careful as well. Unilateral loose wire Drum