圆锥形套筒冠义齿的制造工艺(国外英文资料).docVIP

圆锥形套筒冠义齿的制造工艺(国外英文资料)The conical crown is made up of a conical crown and outer crown that is attached to the base teeth and is formed by the wedge of the crown and the outer crown. Because of its crown as the cone Angle has a certain cohesion, and thus in multiple parallel in place of abutment, abutment retention force tonic, easy operation, etc, and clear the size of sleeve crown is better than the other way. This paper mainly introduced the manufacturing methods, steps and points of the conical crown.Make a removable type on the task modelThe manufacturing method of the crown can be used in the same way as the conventional fixed crown and bridge removable generation. It is only to require that the upper part of the task die be made into a removable form, so that the wax and metal will be worn when the inner crown is made. A common base tooth must be a nail (preferably with a removable nail with two piles to make it more accurate), and the adjacent teeth will have two nails in three to four.Measuring and adjusting with parallel cutting machineClinically to sleeve crown, part of the denture retainer to choose a few more abutment teeth, in order to ensure that multiple sleeve crown can parallel in place, need to adjust the abutment on the task model design. First, the removable type task module is fixed on the task surface of the parallel cutting instrument, and the special calibrator is installed at the head of the instrument. Ordinary abutment teeth to teeth and adduction 2 ° ~ 6 °, the cohesion and Angle is smaller, the better the retention, but relatively parallel difficulty in place. As a result, the calibration is adjusted to the calibrated scale and the individual base teeth are measured in accordance with the fixed position and position of the base teeth. If determine the abutment teeth of the cohesion and Angle of 6 degrees, need to set the calibrator to 6 °, the base developing crowns axial surface measurement and adjustment. For dental crowns axial plane a