小红旗轿车ABS故障排除7例(国外英文资料).docVIP

小红旗轿车ABS故障排除7例(国外英文资料) Seven cases were excluded from ABS of the small red flag Case 1 A red flag CA 7200E3 car ABS light. With the car king test, the right rear wheel speed sensor failure is shown. First, the right rear wheel speed sensor resistance is detected, and the resistance is normal and the sensor is normal. Then the sensor clearance is detected when sensing Device to be removed after, found that the sensor head have been serious wear and tear, this suggests that the sensor gap is too small, led to the top of the sensor with the ring gear grinding, and a sound also reflect the right rear wheel has a sound (the owner). In this case, change a new sensor, and use a screwdriver to sensor bracket as shown in the picture on the right, the steel plate to pry, adjust the gap to the standard scope (if not will wear), test all normal (ABS lamp no light and no sound). Because sensor stents are extremely prone to deflection distortion, the result is a change of sensor clearance. When the gap is over an hour, the signals will be sent out of the sensor and will not be able to signal a different signal, and the ABS light will be on. Figure 1 1 - rear hub shaft 2 - outer bearing 3 - ring 4 - rear brake drum 5 - tighten bolt 6 - sensor bracket 7 - tighten nut 8 - spring washer 9 - rear wheel speed Case 2 A red flag CA7200E3 car ABS light. First, the instrument is tested, and the left front wheel speed sensor is broken. It is normal to use the multimeter to detect the sensor resistance, the resistance is normal, and the resistance is measured from the ABS ECU. It looks like it might have been a spontaneous failure. After the failure code is cleared, the test car is tested, and the ABS light is on, and the instrument still shows that the left front wheel speed sensor is off the road, and the electrical resistance from the ECU is still normal. Repeatedly tried five or six times, each time showed the same failure code, and every time the detection sensor was normal. It looks l