循环水开车(国外英文资料).doc

循环水开车(国外英文资料) The circulating water system stops and drives after a long period of parking 7.1.1 driving conditions 1) the drug system and the filter system have been repaired. 2) cooling water tower fan, circulating water pump, valve, circulating water technology pipeline and heat exchanger have been repaired. Power supply, the instrument power supply is equipped with electric power. The instrument has been adjusted. Chemical cleaning agent, prediaphragm, corrosion inhibitor and fungicide have been delivered to the scene. 6) the sink and the sink have been swept clean. The clean water plant has been driving normally and can provide qualified and sufficient circulating water to replenish water. 7.1.2 drivers 7.1.2.1 hydraulic flushing of circulating water system 1) close the drain valve of the sink and the sink, and water the sink, the water turbidity is less than 5ppm, and the total Fe is less than 3mg/l (in Fe). 2) open the cooling water tower bypass valve and circulating pump circulation valve and close the blow-off valve. 3) when circulating water suction tank liquid level to high level (overflow), according to the program start circulating pump P - 06001 - b, establish circulating water, adjust the circulating valve of the circulating water pump, to adjust the water flow is not lower than 8000 m3 / h, ensure flushing velocity in 2-3 m/s (pay attention to the circulating water pipe network high exhaust pump after). 4) in the process of circulation, analyze every 4 hours a circulating water turbidity and total Fe, when turbidity is greater than 20 parts per million, total Fe is greater than 5 mg/l, maximum filling water and sewage. 5) the circulating water pipe is well developed when the total Fe is less than 5mg/l when flushing is less than 5mg/l. 6) open the valve on the tower, bypass valve closed cooling tower, let the rinse water tower packing, until the rinse water turbidity stable rise, no longer flush end packing. Stop the circulation pump. 7) drain water