技术要求一般模板(国外英文资料).docVIP

技术要求一般模板(国外英文资料) To summarize, there are approximately the basic technical requirements of the following areas for reference (specific figures, specific terms and conditions determined by the designer according to the actual situation) : General technical requirements: The parts remove the oxidized skin. On the surface of the parts, there should not be any defects in the surface of the parts, such as scratches and bruises. Remove the burrs. Heat treatment requirements: Through the processing of the adjustment, HRC50 ~ 55. Parts of high frequency quenching, 350 ~ 370 ℃ tempering, HRC40 ~ 45. The carburizing depth 0.3 mm. Conduct the high temperature aging process. Tolerance requirements: The non-shape tolerance should meet the requirement of GB1184-80. The unfilled length size allows the deviation to be plus or minus 0.5 mm. The casting tolerance band is symmetrical in the basic size of the blank casting. Part angles: No rounded radius R5. Did not note chamfer are 2 x 45 °. Acute blunt. Assemble requirements: The sealing parts must be soaked before assembly. Assembly of hot charging rolling bearings allow used engine oil heating, oil temperature shall not exceed 100 ℃. After the gear box is assembled, the design and procedure shall be carried out in an empty load test. No shock, noise, temperature rise and leakage shall be allowed to exceed the relevant standards. After gear assembly, the contact spots and sides of the tooth surface should meet the requirements of GB10095 and GB11365. When assembling hydraulic systems, the sealing filler or sealant shall be used, but should be prevented from entering the system. The assembly parts and parts (including the foreign purchase and foreign products) shall be assembled by the certification of the inspection department. Parts must be cleaned and cleaned before assembly, no burrs, flying edges, oxidized skin, rust, cuttings, grease, stain, dust etc. Before assembly, the main coordination size of the parts, especially the size