导体载流量的计算口诀(国外英文资料).docVIP

导体载流量的计算口诀(国外英文资料) Chapter ii the calculation of the traffic flow of conductors USES: the amount of traffic (safety current) of various wires can be found in the manual. But with the simple calculation of the legend, you can directly work out the table. Wire carrying capacity and load of the conductor surface, also with the conductor material (aluminum or copper), model (insulated wire or bare wire, etc.), laying method (Ming fu or wear tube, etc.) and temperature (25 degrees or more) and so on, influence of many factors, the calculation is complicated. 10, 5, 1, 0, 0, 2. Two, five, three, five, four, three. Seven, zero, ninety-five, two and a half. The temperature of the tube is 90% fold. The naked line is half. Copper wire upgrade calculation. Description: the key is the aluminum insulated wire, which is applied to the ambient temperature of 25 degrees. If the condition is different, there is another explanation. The insulation line includes various types of rubber insulated wire or plastic insulated wire. The flow rate of the various sections of the cross section (current, Ann) is not directly pointed out, but by a certain multiple of the cross section. To do this, you should familiarize yourself with the section of the wire, (sq mm), 1, 1.5, 2.5, 4, 6, 10, 16, 25, 35, 50, 50, 50, 50, 150... The area of the aluminum insulated wire in the manufacturing plant usually starts at 2.5, and the copper core insulated line starts at 1. The naked aluminium wire starts at 16; The bare copper wire starts at 10. The legend points out that the aluminum core-insulated conductor flux (Ann) can be calculated according to the number of sections. The Arabic digital representation of the cross section (square mm) in the tip is a multiple of Chinese characters. The link between the cross section and the multiple is as follows:.. 10, 16-25, 35-50, 70-95, 120... Three times as much as five times as much as four times as much as two and a half times as much as two times Now and again th