电机故障处理2(国外英文资料).docVIP

电机故障处理2(国外英文资料) (1) the motor does not start The power supply is not connected: check the switch, dissolve the wire, each pair of contact points and the motor outlet line head. 2. Winding circuit: the breaking parts heated to the temperature of the insulation class is allowed. The paint to soften, then break line start, with the same specification after repair welding of broken part, pack good insulation, then through painting, drying process. The winding ground or interphase and interturn short circuit: the processing method is the same, only the ground or the short circuit position is the insulation, then the coating is dried. Winding connection error: check the wiring diagram and repress the end of the connection (including lashing, insulating and painting). The melt is broken: the reason is found out, the fault is eliminated, the motor specification is fitted with the new melt. 6. Wound rotor motor start wrong operation: check the collector ring short circuit devices and starting rheostat, startup should be 0 concatenated rheostat, start again after the completion of the short circuit device. Overcurrent relay setting is too small: adjust properly. The old fashioned switch oil cup is short of oil: add new oil and meet the oil line. Control device connection error: correction connection. (2) when the motor is connected to the power supply, the filament is burned Single phase start: check the power cord, electric tracer, fuse, switch contact, find fault line or false connection to repair after failure. Fixed, rotor winding ground or short circuit: correct errors. The motor load is too large or stuck: the load is adjusted to the rating and excludes the drag failure. 4. Solution cross-sectional area is too small, cant afford to melt the motor overload protection, should press type generally choose melt, melt rated current = locked-rotor current / 2 ~ 3. The starting resistance of the rotor motor is too small or short-circuited: to eliminate short-circuit failure or