IGBT 缓冲电路.pdfVIP

Snubber Considerations for IGBT Applications by Yi Zhang, Saed Sobhani, Rahul Chokhawala International Rectifier Applications Engineering 233 Kansas St., El Segundo, CA, 90245 USA Abstract - Snubber circuits can be used to protect fast Note that the fault current transients are more switching IGBTs from turn-on and turn-off voltage effectively protected by considerably slowing the rate transients. Snubbers are available in various of fall of fault current. Fault current turn-off protection configurations and a clear understanding of their through electronic gate control is convered in detail operation is necessary to make the appropriate elsewhere[1]. selection. This paper will discuss pros and cons of these circuits. Decoupling capacitors, RCD voltage Decoupling Capacitors clamp circuit, RCD charge-discharge snubbers are As mentioned earlier, the magnitude of transient voltage included in the discussion. depends on the trapped energy in the circuit stray inductance, also call “DC loop” inductance LS. As a Introduction preventive measure, steps should be taken to improve When a power device is abruptly turned off, trapped the circuit layout. Usage of laminated copper plates, energy in the circuit stray inductance is dissipated in minimizing the size of the “DC loop” and choosing the switching device, causing a voltage overshoot source capacitance with inherently low self inductance across the device. The magnitude