ADAMSAssignment5ME451KinematicsandDynamicsof摘要.pptVIP

* * * * * * * The following demo might be helpful to understand why they perform an initial static analysis, and also the complexity of contacts in a model: - Set your model_display to At every Iteration. - Zoom in close to the cam. - Perform a static simulation then a dynamic simulation. * * * * * * WS21-* ADM701, Workshop 21, January 2006 Copyright? 2006 MSC.Software Corporation ADAMS Assignment 5 ME451:Kinematics and Dynamics of Machine Systems (Spring 09) CAM-ROCKER-VALVE Rod Cam Rocker Guide (ground) Valve Valve displacement (mm) Time (sec) Problem statement Design a cam profile based on desired valve displacement, and ensure that there is no follower liftoff when the cam is rotated at 3000 rpm. Rod Cam Rocker Guide (ground) Valve Valve displacement (mm) Time (sec) Model description The model represents a valvetrain mechanism. The cam is being rotated at a velocity of 1 rotation per second. The rocker pivots about a pin attached to the engine block (ground). The valve displaces up and down as the rocker moves. When the valve moves, it lets small amounts of air in the chamber below it (not modeled here). Note: At the location of the translational joint, between the valve and ground, the model includes a spherical dummy part. You will use this dummy part when you make the valve a flexible part. This dummy part will not affect the rigid body dynamics. Open ADAMS/View from some working directory Import the file valve_train_start.cmd. The file contains a model named valve_train. Apply motion To apply motion: Use the Translational Joint Motion tool to add a motion to the joint, Valve_Ground_Jt, such that its displacement appears as shown next: Add two STEP functions. Tip: The functions should look as follows: STEP(time, .4, 0,.6,13)+ STEP(time,.6,0,.8,-13). Run a 1-second, 100-step simulation to verify that the valve displaces as a result of the joint motion. Create a cam profile Use a point trace to create a cam profile. To use a point tr