基于气流组织CFD优化的某报社印刷车间空调系统设计.pdfVIP

113 睡通空调HVAC 2012 年第42 在第 11 期 设计参害 基于气流组织 CFD 优化的某报社 印刷车间空调系统设计头 中国轻工业西安设计工程有限责任公司喻继平食何援 西安建筑科技大学赵玉娇A 邵敏李安桂 摘要介绍了某报社印刷车间现有空调系统存在的问题，分析了印刷车间可能采用的 4 种气流组织方式的优缺点，得出异侧分层送风方式优于其他方式。在设计送风口时，结合印刷 机本身的高度和印刷报纸对风这限制的要求，上层在 8.0 m 设计双层百叶风口，保证对印刷机 上部的冷却F 下层 4.5 m 处设计 45。旋流风口送风。运用 CFD 技术研究丁送风速度、风口高度 lt送风角度变化对车间温度场和速度场的影响，结果表明，百叶风口风速 5 m/s，向下倾斜矿， 旋流风口风速4 m/s ，向下倾斜 45 0，下层回风口分别距地距地面 Om 和 1m是最适合该印刷车 间的送风方案。 关键词高大空间 气流组织 空调系统·送风口 回风口 Air condi1ioning sys1em design and the air distribution optimization with CFD for 0 newspaper printing shop By γυ J/ρInQ食 ， He γυ0门 ， Zhoo γUJ / ο0 ， Shoo 问l 门 ond L/ Angυl Abstract Presents the existing problems of thè system , and analyses the advantages and disadvantages of the four types of air distribution. The results show that the opposite-side-supply stratified air conditioning system is superior to other systems. The air outlets being designed with the consideration of the height of the printing machine and the air velocity limit , the double registers are installed at the height of 8.0 m for cooling the space over th巳 printing machine and twist outlets are installed at 4.5 m at an angle of 45. Inv巳stìgates the influences of air velocity , outlet installation height and supply angles using CFD technology , from the available data , concluding that the aìr distribution is the most desirable.when the air velocity of registers is 4. 5 m/s , at a O angle and the air velocity of twist outlets is 4.5 m/s , at a 45 angle , while the return air inlets are installed at 0 m andl m above the ground. Keywords large spa∞， air distribution , air conditioning system , air outlet , ret