CAD高级技巧大全(国外英语资料).doc

CAD高级技巧大全(国外英语资料) Selection skills: In the choice of editing, sometimes accidentally choose a pixel, at this point in the command before the end does not need to cancel orders again, simply enter remove in the target prompt, and then one by one pixel at the prompt what alternative (of course, not too much, otherwise difficult to choose!) to fix. 2. share my AutoCAD tailoring skills As shown in the figure, to the right part of a circle (or other border) outside the line cut, the common way is to choose clipping boundaries and then choose to cut the line, in fact AutoCAD more simple way, the practice is as follows: 1. perform the cropping command by convention, and select clipping boundaries (carriage return confirmation); 2. when prompted to select the line element to be cut, enter f (fence) and enter the confirmation; 3., in the prompt: First Fence point, draw with the line segment to cut the continuous rubber band line, enter OK (see icon). There are 2. points to note: 1., the rubber band does not need to be closed in a straight line. 3.Remove can be replaced by [Shift] +object more convenient. 4. how do you refer to the ACADs form and position tolerance in the WORD table (shown in the red frame area)? In fact, it is simple, but afraid some beginners dare not try! 1. set the background of ACAD to white, otherwise the background color cannot be processed in WORD; 2. in ACAD alone directly tol frame, try to enlarge the display to the entire drawing area; 3. using ACAD copyclip (copy to clipboard) command, select the shape and position tolerance frame; The 4. switch to the WORD table, and paste, but this time the entire table will be packed at this point is very chaotic, resistant to nature, with the use of WORD image editing functions will shape tolerance frame extra edge cut, and drag and drop shape suitable size and position tolerances of frame images to form within the scope for the benefit. Operation, the document display magnification. To be sure, the general ty