DC电源插座在短路电流中电压相位的变化(国外英语资料).docVIP

DC电源插座在短路电流中电压相位的变化(国外英语资料) Changes in voltage phase in short circuit current for DC power outlets The main circuit resistance of the switch socket can be measured directly by means of a micro ohm meter or a low voltage dual bridge. The advantages of this measurement method are more intuitive and convenient for DC power outlets. Due to the shortcomings of measuring the current through the switch is very small, not destroy the contact surface of the oxide film, resulting in larger error (larger). So this method is not recommended in the loop resistance measurement in high voltage switch. Using the pressure drop method (Fu Anfa) indirect measurement method is: the pressure drop switch socket connected to DC current value, drop voltmeter switch socket outlet end between the (mV), and then the main loop resistance switch socket calculated using Ohms law. Measuring circuits using transformers and silicon rectifiers. At the same time with the main loop resistance pressure drop measurements because the current through the sample of large enough to break the contact surface of the gold film, the measurement error is reduced and the measured value is more accurate, so the measurement of main loop switch socket recommended using the pressure drop method. The DC component in the switching or short circuit current varies with the phase change of the voltage occurring in the short circuit. The momentary of the short circuit of the switch socket is random, so the starting value of the direct current component in the short circuit current of the switch socket is changed. The DC component value of the single-phase circuit of the switch socket ranges from 0 to 100%. The changing range of the DC component between the switch socket and the three-phase circuit can be divided into two cases. Firstly, when the neutral point and the short circuit point of the power converter are directly grounded, the short-circuit current of the switch socket is related to the zero sequence impedance. Z