万用表各挡量程选择及测量误差分析(国外英语资料).docVIP

万用表各挡量程选择及测量误差分析(国外英语资料) Multimeter, range selection and measurement error analysis,.Txt and handsome men shake hands, and deep men talk about heart, and successful men more exchanges, and ordinary men live. Measuring with a multimeter can lead to certain errors. Some of these errors are the maximum absolute error allowed by the accuracy level of the meter itself. Some are man-made errors caused by adjustment and misuse. A correct understanding of the characteristics of the multimeter and the causes of the measurement errors, and the correct measurement techniques and methods, can reduce the measurement errors. The human reading error is one of the reasons that affect the measurement accuracy. It is unavoidable, but it can be minimized. Therefore, in use should pay special attention to the following points: 1 placed multimeter to measure the level of the mechanical zero; and to keep the vertical eye Reading 2 pointer; 3 resistance measurement, one for each block should be zero. To adjust to zero to replace the new battery; 4 measurement of resistance or high pressure, metal parts cant hold hands pens, so as to avoid the human body resistance shunt, increasing the measurement error in the measurement of RC or shock; 5 in the circuit resistance, to cut off the power supply circuit, and the capacitor electric discharge end then, measure. After excluding the human reading error, we analyze some other errors. 10 thousand table voltage and current block range selection and measurement error The accuracy level of the universal meter is generally divided into 0.1, 0.5, 1.5, 2.5, 5 and other grades. DC voltage and current, AC voltage and current of each block, accuracy (precision) level calibration is determined by its absolute maximum allowable error of the X value and the selected range of the percentage of the full scale value. In the formula: A%= (X/ full value) * 100%...... One (1) the error of the same voltage is measured by a multimeter with different accuracy For ex