实验一 单调谐高频小信号放大器(国外英语资料).docVIP

实验一 单调谐高频小信号放大器(国外英语资料) Experiment 1 single tuned high frequency small signal amplifier First, the purpose of the experiment 1. 、 familiar with electronic components and high frequency circuit experiment box. 2. familiar with amplitude frequency characteristic analysis of resonant circuit - pass band and selectivity. 3. familiar with and understand the dynamic range and testing methods of amplifier. 4., familiar with the signal source, internal resistance and load on the resonant circuit, so as to understand the frequency band expansion. Two 、 experimental instrument 1. double track oscilloscope SS-7804 2. sweep frequency PD1250 3. high frequency signal generator WY1052 40 thousand meter 5. experiment board 1 Three, preview requirements 1. Review the working principle of the resonant circuit. 2. Understanding the voltage amplification, dynamic range, pass band and selectivity of the resonant amplifier. 3 、 in the experimental circuit, if the inductance is L=1uh, the loop total capacitance C=220pf (distributed capacitance included), the loop central frequency f is calculated. Four, the experiment content and steps (1) single tuned loop resonant amplifier. 1. the experimental circuit is shown in Figure 1-1 (1) connect the circuit as shown in Figure 1-1 (note that the +12 V supply voltage is measured before the connection and without error Disconnect the power supply again (2) check carefully after wiring and make sure the power is on. 2. static measurement Selecting Re=1K in experiment circuit Measure the static work points, calculate and fill in the form 1.1 Table 1.1 Actual measurement Measured calculation According to the VCE, does the V work in the amplification area? Reason VB VE IC VCE yes no * VB, VE is the base and emitter to ground voltage of the triode. 3. dynamic study (1) the dynamic range of the amplifier is measured at Vi~VO (at the resonant point) Choose R=10K, Re=1k. The high frequency signal generator is connected to the input end of the circuit, and