飞机用小制件注塑模具设计.docVIP

飞机用小塑件模具设计 摘要 本文说明了制件设计及塑料模具设计的全过程。制件、模具零部件造型全部用软件完成。在对制件分析的基础上完成了方案的选择，工艺及尺寸计算，完成了模具零部件装配，同时考虑了零部件的加工。设计中加入嵌件，斜滑等模具特有的一些结构。模的靠斜来完成，当斜滑杆充当顶杆向上推出塑件时，由于斜度的作用，斜滑杆同时水平方向平移一个距离，即为侧向抽芯距，它们用来完成零件部的孔。 关键词: 塑料模具；标准件；侧向抽芯；性能尺寸 Based on pro / e of the aircraft with a small plastic mold design Abstract This article describes the design of remote control and plastic rear cover parts of the whole process of mold design. Parts, mold parts and components of all shapes with pro / e software. Of parts based on the analysis of the choice of the completion of the program, technology and size, the complete assembly of the mold parts, at the same time taking into account the processing components. Insert to add the design of inclined slider and so on some of the unique structure of mold. Mold is divided into two sub-type, respectively, carried out in the middle of typing the following on the board. Typing out the first condensate is expected. The second type of plastic pieces in the completion of the side hole at the bottom of the top of the plastic parts at the same time. Dynamic part of the side by the concave ramp to complete the push-rod, when the slider ramp up to serve as the introduction of plastic parts and push-rod, because the role of gradient, ramps slider at the same time a shift away from the horizontal direction, that is, core-pulling away from the lateral On the other hand, can play the role of push-rod, and they used to complete parts of the concave side hole. Keywords: plastic mold；pro/e Standard Parts；Side-core machine；Performance Dimensions 目录 摘要 I Abstract II 目录 III 1 绪论 1 2 塑件材料及尺寸对模具的影响 2 2.1 塑料材料性能分析 2 2.1.1 塑料工艺性能分析 2 2.2 塑件的工艺分析、确定方案 4 2.2.1 塑件的尺寸 4 2.2.2 塑件的尺寸精度 4 2.2.3 脱模斜度 5 3 模具结构形式的拟定 6 3.1 塑件结构分析 6 3.2 确定模具结构方案 6 3.2.1 型腔数量及排列方式的确定 6 3.2.2 模具结构形式的确定 7 4 注塑机型号的确定 7 4.1 注射机的选择 7 4.1.1 注射机初步选择 7 4.1.2 注射机的主要参数 9 4.1.3 注射机及型腔数量的校核 10 4.1.4注射机及参数的校核 10 4.2 标准模架的选择 12 5 分型面位置的确定 12 5.1 分型面的形式 13 5.2 分型面的设计原则 13 5.3 分型面的确定 13 6 浇注系统的形式和