软性结构材质介面黏着强度与疲劳耐久性分析.PDFVIP

2014 SIMULIA Regional User Meeting  軟性結構材質介面黏著強度與疲勞耐久性分析 李詩寧、葉瑞嘉、蔡進源 寶成工業股份有限公司 摘要 本研究主要目的是為提供方法，評估軟質材料之疲勞壽命耐久分析。透過有限元分析 軟件 ABAQUS模擬進行軟質材料下彎曲試驗疲勞分析。網格模型建立、邊界條件設定及 負載施加，並以疲勞實驗 SN曲線進行驗證，建立正確分析模型。應用有限元素法搭配應 力疲勞壽命曲線圖可以快速和有效評估軟質結構材料壽命破壞形式。研究架構分為實驗與 分析兩部分，實驗部分內容為疲勞實驗，並從實驗結果討論不同破壞模式之黏著強度，然 後由單邊搭接方式取得應力疲勞壽命曲線圖。藉由實驗結果討論不同破壞模式之黏著強 度，以單邊搭接方式取得應力疲勞壽命曲線圖。並建立有限元模型模擬分析法，模擬軟質 結構材料用於鞋底受彎曲之狀態並且觀察應力集中區以及應力分佈狀況。最後依照模擬結 果比對應力壽命曲線圖並且評估黏著強度壽命；軟性結構材質運用此模擬流程執行疲勞分 析，可有效縮短產品開發時程及降低測試成本。 關鍵字：彎曲、疲勞強度、單邊搭接測試、有限元素法 ABSTRACT The major is purpose to provide methodology to evaluate the lifetime of structure of soft material with fatigue analysis. The fatigue analysis for structure of soft material under bending test is performed by the simulation of finite element software Abaqus. The modeling of mesh size, boundary conditions, and loadings is experimentally verified by the stress measurements. This study consists of the experiment and simulation to the S-N curves have been explored by fatigue test. The results from the tests could investigate the failure modes to structure of soft material adhesive strength by rapid and effective method to study the mechanism and fatigue life in a simulation. The results from the tests could investigate the failure modes of adhesive strength. The S-N curves have been explored by fatigue test. The three dimensional finite element models has been used to analyze bending state of sole by structure of soft material. Observe the position of stress distribution and the location of the maximum stresses, this result could lead to find out the lifetime with S-N curve. The fatigue analysis of structure of soft material by finite element simulation could reduce the development time and testing cos