高压灌浆(国外英语资料).docVIP

高压灌浆(国外英语资料) I. basis for compilation 1, the project site investigation of the specific situation: found subway tunnel wall leakage, water; 2. Technical specification for engineering waterproof GB50108-2001; 3. Code for acceptance of waterproof works GB50208-2002; 4, the relevant provisions of the current state regulations. Two 、 construction principle and method Adopt high pressure grouting to block water treatment. 1, determine the waterproof scheme: must conduct on-site investigation before plugging, to find out the site construction conditions, analysis of the causes of seepage Water Leakage, identify Water Leakage parts, crack, crack or perforation of the width, length, depth and penetration, and to understand the situation Water Leakage sunny and rainy days, the Water Leakage measurement of flow and velocity and so on, through the full investigation the correct formulation, sealing solutions, do the preparatory work. 2. material properties: oily polyurethane rapid plugging glue and water reaction, because the water in the reaction, the slurry can not be diluted with water washed away, this is the advantage that other filling materials do not possess the slurry under pressure, pouring concrete cracks or holes, at the same time to penetrate the gap around, continue to penetrate into the concrete cracks, finally the formation of network structure, a low density, elastic body water, has a good ability to adapt to change, good waterproof. 3, the design of grouting hole and hole hole hole filling and a slant hole two forms to choose according to the actual situation and needs, and both when necessary. (1) the design of grouting hole: the location of grouting hole should make the hole intersect with the water leakage, cracks and voids, and select the maximum water leakage. (2) hole principle: the position and number of grouting holes, reasonably arranged according to the different situation of | Water Leakage examination |, to derive Water Leakage for the purpose, i