铁素体不锈钢高温循环氧化性能特征-应用昆虫学报.PDFVIP

下半月出版 Material Heat Treatment 料热处理技术 铁素体不锈钢高温循环氧化性能特征 孙宾, 王守仁, 王砚军 (济南大学 机械工程学院, 山东 济南 250022) 摘 要 采用增重法研究了1Cr 17 铁素体不锈钢在900 空气中循环氧的高温动力学 并结合扫描电镜尧能谱分析 以及X 射线衍射等手段 对氧化膜形貌尧成分和组织结构进行了分析研究遥 结果表明 1Cr 17 铁素体不锈钢在900 氧化 时 初期增重较快 随着循环次数的增加 氧化增重有所减小且遵循抛物线规律曰1Cr 17 铁素体不锈钢在900 下经 240 次循环氧化后 形成了双层氧化物膜并且产生了大量裂纹和空隙外层以Fe O 和Fe O 为主 内层以Cr O 为主遥 2 3 3 4 2 3 关键词 铁素体不锈钢曰高温曰循环氧化 中图分类号 TG 172.82 文献标识码 A 文章编号 Cyclic Oxidation Behavior of Ferrite Stainless Steel at High Temperature SUN Bin, WANG Shouren, WANG Yanjun (School of Mechanical Enginee ring, Univ ers ity of Jinan, Jinan 250022, China) Abstract 院The cyclic oxidation of 1Cr 17 ferrite stainless steel at 900 in air was studied by weight gain. The surface morphology, constituent and microstructure of the oxidation scale were analyzed by SEM, EDS and XRD. The results show that the cyclic oxidation curve of 1Cr 17 ferrite stainless steel at 900 is approximately parabola. After 240 cycles oxidation at 900 , the oxidation scale with a lot of cracks and cavities includes two layers. The out layer of the scale is made up of Fe O 2 3 and Fe O , inner one is mainly Cr O . 3 4 2 3 Key words 院ferrite stainless; high temperature; cyclic oxidation 着我国汽车工业的迅速发展 在汽车用钢中 1 实验