13春学期《钢结构(一)》在线作业2(国外英语资料).doc

13春学期《钢结构(一)》在线作业2 Northeastern University, 14 spring, 13 autumn East, 13 spring semester, steel structure (1) online homework 2 Total score: 100 test time: - Radio examination Radio examination questions (20 questions, 100 points) About 1. of the bolt and rivet connection, the following statement is wrong _________. A. the number of permanent bolts should not be less than two at each end of the joint and at one end of the splice joint B. in the high strength bolt connection area, the component contact surface treatment method should be explained in the construction drawing C. the pull connection of ordinary bolts that are directly subjected to dynamic loads shall be double nuts or other effective measures to prevent loosening of the nut D. common bolts can be used for shear connections directly subjected to dynamic loads Full marks: 5 2. fixed beam under concentrated load, the compressive stress can not meet the requirements, the ______ is a more reasonable measure. A. thickening flange B. support stiffener is set at concentrated load C. increases the number of transverse stiffeners D. thickened Web Full marks: 5 Three A. A B. B C. C D. D Full marks: 5 Four Because of bending normal stress, A. needs longitudinal stiffener Because of bending normal stress, B. needs transverse stiffener Because of the shear stress induced buckling of C., longitudinal stiffeners should be used Because of the shear stress induced buckling of D., transverse stiffener is required Full marks: 5 5. steel cold hardening, the ___________. A. strength increased, plasticity and toughness decreased The strength, plasticity and toughness of B. increase The strength, plasticity and toughness of C. decrease D. reduces plasticity and increases strength and toughness Full marks: 5 6. batten type axial compression column with lacing bars according to axis pressure bar design, but the strength of steel should be multiplied by the reduction factor to consider ______. Effect of A. shear force The influ