cohesive-说明-2(国外英语资料).docVIP

cohesive-说明-2 When 6.5 uses cohesive element to define cohesive material properties, the main steps: 1. define the name of a material, such as cohesive, and do not define any attributes (elasticity, elasticity, plasticity, etc.). 2. open the Toolbar model--edit keywords and manually add various properties of the material in inp. When PS: defines section, select cohesive, element control, select sweep, element type, select cohesive, these are the basic steps of using cohesive element. The cohesive section settings for zero thickness What ABAQUS calls zero-thickness is actually the initial section that defines cohesive thickness=1.0. You can define in the definition of section (specify), you can also use the system default thickness (also 1), so the cohesive element calculation, there are displacement (displacement) =strain (strain) *thickness (1) =strain value. We know that from 1914 Ingless and 1921, Griffith proposed that fracture mechanics started until 60s and stayed at the level of online elastic fracture mechanics (LEFM). Later, LEFM was still unable to solve the stress singularity problem because it was found to enter the plastic zone at the crack tip. In 1960 by Barenblatt and Dugdale first proposed the concept of nonlinear/plastic fracture mechnics, plastic zone introduced in the crack front, this is what we now use cohesive fracture mechnics predecessor. At the time, the concept had not yet caused a sensation in academia. Until 1966, Rice found J-integral and subsequently found that J-integral in LEFM is equal to energy release rate (Daniel Rice like a Ph.D in reading period derived is important for fracture mechanics J-integral... We, real shame). Subsequently, more and more problems that LEFM can not explain are found in engineering. Cohesive fracture mechnics is starting to attract more attention. In the study on concrete as the representative of the quassi-brittle material, cohesive fracture mechnics provides very good results, so in 70s 90s, cohesive