m1083无意磨床抱轴处理(国外英语资料).docVIP

m1083无心磨床抱轴处理 M1083 centerless grinding machine holding axle (Reprint) Tags: centerless grinding machine Grinding wheel spindle (grinding wheel spindle) bearing research reasons mainly in two aspects: first, lubricating oil pump delivery line obstruction: second is to enter the bearing oil cavity main oil line obstruction. These two reasons will directly lead to the insufficient oil or oil pressure in the oil bearing cavity of the bearing cavity, resulting in the failure of the bearing pair when the main frame of the grinding wheel is started. The main part of the delivery circuit is the oil filter. M1083A sent a total of three heavy oil oil filter, especially the filter is easy to block or filter paper melt resulting in send oil pressure drops, the oil shortage, the low oil pressure, while the spindle start electrical interlocking system failure, resulting in the death of hydrostatic bearing deputy research. The \5 X/ D* E9 WL. D9 l$h. L The oil passage into the bearing oil chamber is blocked mainly at the gap of the film feedback throttle valve. Serious obstruction clearance, into the oil chamber of the oil to small volume, low oil pressure, the spindle is not well in the bearing float, if the grinding wheel is not to move or very heavy, at once started grinding spindle is also caused by the death of hydrostatic bearing deputy research. (b) N1, R7], p# { 1.2-105mm and the bearing clearance between 0.055 ~ 0.060mm2.2-, 105mm ellipticity, taper tolerance, 0.002mmM1083A grinding wheel spindle diagram, M1083A grinding wheel spindle parts, such as the right. 2 repair process, we will remove the main shaft of the grinding wheel, we found that the main fault is in front of the spindle bearing, and then there is no obvious trace of the rear bearing. First we use the micrometer on the spindle front neck for accurate measurement, the actual size is 105-0.008-0.007mm, with inner diameter micrometer measured bearing bore diameter? 105+0.048+0.051mm, thus its clearance betwee