压力试验机(国外英语资料).doc

压力试验机 structure - temperature probe: xuanru type thermocouple, temperature sensitive, uniform, high precision. - heater: xuanru type heater, fast heating power, strong and durable. Post - copper sleeve: the brass is refined, and no abrasion resistance. In the power system: using special motor, so that smooth operation, accurate, no noise. - Safety Protection: a report of an emergency protection device, in case of emergency can make the machine to stop or reverse. performance Tensile test pressure test machine: tensile test (stress-strain test) is a general material sample are respectively sandwiched between two spaced fixture, the fixture two to a certain speed separation and determination of tensile specimen, specimen stress changes, until the sample is destroyed. Tensile test of tension machine is one of the most widely used methods to study the mechanical strength of materials. According to the difference of load measuring methods, they can be divided into two types: computer universal tensile testing machine and electronic tensile testing machine Installation debugging install Test machines shall be installed in clean, dry, non vibration, non corrosive gas affected rooms. Installation of Foundation (see Figure two) shall be firm and reliable, and the foundation bolt shall be secured to the base. The machine is adjusted to level. After installation, apply clean and soaked cotton yarn, wipe the rust on the machined surface of the machine, and then wipe the surface clean and coated with a thin layer of mechanical oil. debugging (1) oiling Open the back door, lift the fuel tank lid and pour proper amount of mechanical oil into the tank to the oil mark position. Because of the change of temperature, the oil is slightly different, and the specifications for the oil are as follows: When the ambient temperature is 15 + 5 DEG C, the GB443 - 84N68 mechanical oil is used. When the ambient temperature is 25 + 5 DEG C, the GB443 - 84N100 mechanical oil is used. (2) electric