打印机弊病剖析及处理方法(国外英语资料).doc

打印机故障分析及处理方法 First, the printer output blank paper For the printer, causes printing paper blank mostly because the ink ribbon, ribbon breaking, dry print head damage, should be replaced or repaired in a timely manner the ribbon print head; for inkjet printer, print blank caused by fault is mostly due to nozzle clogging, no ink cartridges, cleaning nozzle or should replace the cartridge for; laser printer, the cause of the fault is probably the developing roller fails to suck the toner (DC bias of the developing roller is not added), may also be the photosensitive drum ungrounded, unable to release the negative charge, the laser beam can not play a role in the photosensitive drum, drum cover or laser scanning protective cover is not open etc.. The photosensitive drum of a laser printer does not rotate, and no image is generated and transferred to the paper. Disconnect the printer power, remove the toner cartridge, toner cartridge open the protective cover, both ends of the photosensitive drum in non photosensitive parts with pen mark after reload machine. Warm up for a while, then remove the toner cartridge to see if the mark is moving. (to determine whether the drum is working properly. ) if a self-test occurs, the blank print is printed. Check that the toner has been used up, the cartridge is correct, loaded into the machine, the sealing tape has been removed or checked, the laser scanning closure is open or has a foreign object block. Two 、 the output of printing paper is black The stylus printer, the reason of the failure is caused by excessive hair removal, ribbon ink ribbon, ribbon printing head dirty, poor quality and putting position too close, maintenance should first adjust the position of the push rod, if the fault cannot be ruled out, replace the ribbon, cleaning the print head, can usually be troubleshooting; for inkjet printers, should key check the nozzle is damaged, the ink tube is broken, the ink type is normal inking pipe is blocked; for a laser