打印机的使用方法(国外英语资料).doc

打印机的使用方法 With the frequent use of copiers. It will inevitably be some small fault. Because of copier maintenance and maintenance of books. Plus the copier is a relatively expensive office appliances. So the most will find professionals to solve. But this way is not only cumbersome and time delay. The author in the process of explore the experience of some small maintenance. Take out and everyone together to discuss (due to the use of multiple machines. So some Minolta takes it as a blueprint. Other similar principle copiers). One copy of the copier has many spots This phenomenon generally have three situations: a glass release copier is too dirty. This is easy to solve. Only need to use a soft cloth dipped in a neutral detergent to wipe the glass platen. The second is the exposure device is dirty. It needs to be removed. Then the glass platen the copier lens wipe clean with camera lens paper. Then several pieces of reflecting mirror (copier device inside like we usually use the mirror like) wipe clean can. There is a copier fuser roller (by mouth. After a copy of import paper hot) stuck on the residual toner. This situation is more common. Especially in a batch copy. Usually this spot is relatively large. And might spot. Then to wear paper in the copier engine case. The first copy of a few sheets of paper. Then the copier cover Open. The fixing component slightly raised. You will see some parts of the fixing roller will stick to something. Use a cotton ball stick in fixing roller of toner can be erased. Pay attention not to use something wet wipe. Because the fixing roller temperature is very high. With the wet stuff may be also damaged. When the refrigerator can not wipe. Because the cooler when the toner sticks fast. Wipe off. If push too hard. The black film break fixing roller. Two. The copy is not good. The paper is black or the writing is unclear This is relatively easy to appear in the winter and high humidity. Because the copier is just starting to reach the