工艺流程指标控制与工艺(国外英语资料).doc

工艺流程指标控制与工艺 Process flow, index control and process fluctuation query processing First, the compressor process specifications 1, in the production of synthetic ammonia process, due to the many processes (transformation, decarburization, carbonation (including variable removal), methanol (ethanol) refining Anhui synthesis of methanol, water), these processes must be carried out smoothly in order to pressure the necessary conditions, so it is necessary to reduce the post delivery pressure of different grades these jobs are auxiliary. Thus, the compressor control process is required, mainly too bad, followed by temperature. In order to operate the compressor process well, it is necessary to understand the relevant section. 2, the most important process indicators are the control of the inlet and outlet pressure and the control of the system pressure. The process is stable, the energy consumption is low, and the system pressure is stipulated: (1) transform: I plant using low pressure control in the transformation of general 0.8-0.9kg/cm2, reason is low on the coal quality requirements are relatively relaxed, easy control and high technology, can save coal in touch, and can be reduced by two, three pressure difference, this is equivalent to lowering the compressor power consumption, improve the three pressure. Less three compression ratio increased by three in the three period of expansion volume, expansion rate increased at the same time, but also can reduce the pressure of transformation. (2) decarburization: our plant decarburization is divided into two pressure levels, that is, 18kg/cm2 decarburization and 27kg/cm2 decarburization. This pressure level is beneficial to the absorption of carbon dioxide and the purification of the gas. Why are kilograms divided by two years? Carbon dioxide solubility in propylene carbonate in increase with pressure, improve the absorption pressure, can improve the degree of purification and 27kg/cm2 in the same operation process than 17