施工放线步调(国外英语资料).doc

施工放线步骤 Construction release procedure The construction line operation line is generally divided into various methods; Longmen plate positioning ruler line and instrument measurement line, according to the former control point or field drawings known to determine, based on on line outside of the building around a certain distance piling, the erection of Longmen plate, a pull to the right angled line construction line in Longmen plate, try to put the line taut, then by using the Pythagorean theorem by the ruler and ruler, the size should be larger, generally 6, 8, 10m, this is more accurate, the first in two control line size measured with a red pencil point, then two people pull the feet, a swing can the thread and steel tape dimensional stability, and then fixed the construction line of Longmen plate, with a steel ruler proofreading again, after confirmation, surrounded by hanging wire, steel check, according to the drawings on the axis dimension with ruler measuring point, use The plumb line is vertical to the ground so that it can be removed with lime powder. The level is measured on the Longmen board with a level meter. 1, the general case is embedded steel in the internal position of pre selected, find the intersection, on the plate with a theodolite notch, as the vertical axis of the measuring point, then use a large hammer line how to hang more convenient. With the point of the line hammer pointing to the axis, notify the personnel on the floor using the intercom when the line hammer is aiming at the reference point. In the alignment below the hammer, the hammer tip point to plate and point difference observed from two perpendicular directions, and notify the upstairs staff timely adjustment of the position of the steel wire, when the hammer tip and cross direction from both sides are coincident, can inform the upper point. As for the problem of elastic steel wire does exist, the key is to put the steel wire strand round on the floor to specially, can small h