汽车音响指标测试方法(国外英语资料).doc

汽车音响指标测试方法 Testing method of car acoustics index One, FM index test method (1kHz 22.5%.DEV) 1 30dB practical sensitivity (USABLE, SENSITIVITY, S/N:30dB) The machine is 90Mhz (98Mhz, 106Mhz), (LEVEL) in the normal level of dB number (about 40), receive fine volume to 0dB, then remove the signal (i.e. ON|, OFF and lay a button) and then twist millivoltmeter (30dB, three, each twist is 10dB). The level and then adjust the signal generator (LEVEL), the pointer and the pointer has no signal signal (if not repeat repeat cannot be more than 1 dBm), the last level (LEVEL) dB shows that this machine -30dB practical sensitivity. Two and 3% distortion sensitivity (I.F.H., SENSITITV, 75khz, DEV, 3%T.H.D) The machine is 90Mhz (98Mhz, 106Mhz), the modulation in the 75% play, will play in the DIST, 10% distortion meter (-20dB) file, and then adjust the volume level potentiometer and generator (LEVEL) dB number, the distortion meter pointer in the 3% place (not more than 3% position. It should always be fluctuations in 3%), then the generator level (LEVEL) dB number is this machine (for example: 3% distortion sensitivity level (LEVEL) the dB number is 11, then the 3% distortion sensitivity is 11). Three, -3dB limit sensitivity (-3dB, LIMITING, SENSITIVITY) The machine is 98Mhz level (LEVEL) in the 66dB number, volume smaller to 0dB, and then reduce the generator level (LEVEL) dB number, to reduce 3 dB MV meter pointer stop, the level of dB (LEVEL) is the number of -3dB limit sensitivity. 4 signal-to-noise ratio (S/N, RATIO, @1mv, INPUT) The machine is 98Mhz level (LEVEL) to play in the 66dB, the volume smaller to 0dB, then remove the signal (i.e. ON|, OFF a button) call millivoltmeter, each twist is 10dB, but the voltmeter pointer cannot exceed 0dB, how much is the last pointer index number plus a total of a millivoltmeter (each file is 10dB), (for example: you played a total of three pointer index is 6, so the signal-to-noise ratio is 30+6=36dB). This is the signal to noise ratio