注塑机压力和流量的关系(国外英语资料).docVIP

注塑机压力和流量的关系 Injection molding machine pressure and flow of the machine itself is to overcome the resistance movement, that is to say the machine to move first must provide a slightly larger than (omitted equal) resistance force in the injection molding machine is also called pressure, only provides the force to move; and the movement is a fast slow branch. This involves the flow, it is the power of the source, in overcoming the resistance to action after flow greater and faster movement, at the same time the faster the resistance is bigger, so it can be said that the movement itself is in equilibrium for power and resistance. Presumably, what we are concerned about is the relation between flow rate and pressure during injection molding and packing. The injection itself is a process of filling the mold cavity with a hot material stream. In theory, if the product surface defect is not considered, the mold factor should be the faster the filling speed. But because of the heat flow in the flow of the process is bound to produce resistance (cavity pressure), is the cavity internal pressure resistance, the machine must be required to provide a greater than or equal to the resistance of the power (liquid pressure injection time) to heat material flow into the die cavity filling, too that is to say the injection action is also in action to overcome resistance. Some people ask, is this stress constant from the beginning of the injection to the end? Definitely not. Even a constant injection (or a speed). Because as the material flow into the mold cavity, the contact surface is constantly expanding, that is, its force area is constantly expanding, so the injection pressure is changing at uniform injection. The injection pressure is certainly changing as opposed to the single stage injection, because the velocity of the flow filling varies as well as the force area being changed. Im sure someone will be confused. How can I set the injection pressure so well? In fact, the set o