消除面板的黄灯(国外英语资料).doc

消除面板的黄灯 How does the minicomputer yellow after the yellow light is shown? The yellow light on the device of IBM power4 (5) series (system warning light) is long, not necessarily hardware error. Cause there are many reasons for this phenomenon, may be due to a hardware failure, may also be due to room environment (such as current, temperature, may also be due to network disconnection), the misoperation of the user (such as non normal shutdown, etc.) caused by. The discrimination method is as follows: 1 diagnose the system and determine if the hardware is faulty. The Root user executes the diag; Enter, enter second, advanced, diagnostics, routines; Select system verification; Select all resources, carriage return; Perform the test by F7; See if there is a failure to return the result. In case of failure, record failure and errpt - A and feed back to IBM company or maintenance agent. 2, if there is no fault. Clear warning light. The Root user executes the diag; Enter, enter third, task selection; Select Identify, and, Attention, Indicators; Set, System, Attention, Indicator, to, Normal, carriage return; Press F7 to perform. 1, find the yellow light on the AIX (alarm) method. 1, diag =task..=log repair... Action = sysplanar0, enter, F7 Method 2, use serial port to enter ASM Problem Description: how to put out the alarm lamp? Answer: In daily work, sometimes encountered on the machine panel orange, there is exclamation mark of the hardware fault alarm light. The hardware fault alarm light is a light emitting diode that indicates that the system has detected a hardware fault and the administrator should pay attention to it. But the hardware fault alarm lamp is very sensitive, in many cases it is not hardware fault develops it light, such as hot swap some signal line or cable, users of non normal shutdown could lead to the warning light. At this point, the administrator should first check the system error log errpt to see if there is a hardware error. If not, then we can