电机与拖动基础6章(国外英语资料).doc

电机与拖动基础6章 The sixth chapter is the electromotive force and flux potential of armature winding of AC motor The sixth chapter is the electromotive force and flux potential of armature winding of AC motor Armature is the key part of the electromechanical energy conversion in the motor. The armature of the DC motor refers to the rotor part, while the armature of the AC motor is the stator part. For the armature winding of AC motor, first of all, the electromotive force of a certain size and sinusoidal waveform can be induced. For three-phase motor, the three-phase electromotive force is required to be symmetrical. When arranging winding, it can not only satisfy the electromotive force requirement, but also satisfy the requirement of winding flux potential. 6.1 electromotive force of armature winding of AC motor Analysis method: single conductor, coil and coil induced voltage, single coil group induced electrical conductor, single coil and single coil coil induction potential group induced voltage, phase winding induced emf induced electromotive force of one phase winding Electromotive force of 6.1.1 conductor Mechanical angle: the geometric angle of the motor the rotor surface occupied by using beta table mechanical angle: space geometric angle of the motor rotor for the whole surface, =360 degrees, beta =360 electrical degrees: space of a main pole for the geometric angle of said electric angle: space of main for the pole geometry representation to 360 degrees), called angle space called angle space electric power. 360 degrees (2 pi), referred to as the angle of the space. In alpha, if the motor has p to the main magnetic pole to the main magnetic pole, 360 degrees, if the motor has the main magnetic pole, the corresponding overall electrical angle is p * 360 degrees, always 360 degrees, so there is a mechanical angle, the beta is always an angle Alpha =p beta When analyzing the principle of a motor, the angle of the electric motor is analyzed by the angle of the space