磨具积垢后若何清理(国外英语资料).doc

磨具积垢后如何清理 Due to precipitation of plastic additives and sediment formed in the pressure roll on the surface, called the fouling, which usually brings great distress to the extrusion process, it will cause a variety of problems, including extrusion or injection molding, mechanical contact surface color caused by attachment, even complete failure processing. Die design and manufacture, simple operation of the production line side helps to remove the mold side fouling. The distribution can be changed by changing the scale in the die extrusion mold from the point of view, help mold cleaning. But, either way, the removal of the scale, all need to pay a high cost producers shutdown. In the mold release agent or export position using silica gel can effectively reduce the fouling generated frequency, prolong machine needs cleaning cycle. Decelerate machine can also reduce the deposit rate, but it will affect the output of the machine. All these methods are palliative. To solve the problem of mental industrial mold deposit give you a call to teach you. First, improve the processing technology Increasing the temperature of the mold and melt is a way of reducing stress at the die exit, but other problems arise, such as degradation of the material, resulting in a sharp increase in the low molecular weight components of the melt. Therefore, changes in melt and mold temperature should be considered separately. Firstly, the melt temperature is determined, and then the shape of the mold is designed according to the melt temperature. Although this is difficult, but in order to eliminate the mold fouling phenomenon, it is worth a try. In addition, the surface temperature of the die outlet is lower than that of the die itself, and surface thermocouples are needed to check the temperature at the die outlet. The air blower at the die exit, can effectively help reduce and control of fouling, blower can be any mist and compressed from the mold, another advantage of this approach is a bla