空调加氟(国外英语资料).docVIP

空调加氟 Charging method for adding fluorine in air conditioner Generally we may use low pressure air conditioning plus fluoride and static fluoridation 1. air conditioning system Lengran from low pressure at the fluoride, when added to the 0.4~0.6 will be, and then observe the refrigeration effect of air conditioner. If possible, the measuring pressure should not exceed 2.2. 2. when the air conditioner is deactivated, add fluorine to the air conditioner at the place where the fluorine is added. When the system pressure reaches 0.8~0.9, it is appropriate 3. let the air conditioner run for 30 minutes, and make a close inspection. (1) the measuring pressure is low and the pressure is 0.4~0.6. If is high, add fluorine, if less, and less fluoride. High pressure can not exceed 2.2 (2) to listen to the sound if the sound is too large, dull, may also be added fluoride, if the sound is too small, not enough that fluoride. (3) the temperature suction pipe cooler, condensation; exhaust temperature at about 80 degrees; the condenser temperature at about 55 degrees; the compressor suction pipe cold dew, the exhaust pipe is hot; the temperature of the evaporator bottom than the ambient temperature around 15 degrees. (4) measuring the total current working current close to the rated current, if the current is too large, then add freon, if the current is too small, and too little freon. The requirements of the system and circuit under normal circumstances test, because there are a lot of relationship between the suction pressure of the compressor working current with the compressor suction pressure, high current, large suction pressure at the end of the current is small, if the system is blocked, then the current compressor will be the bottom, and the sound of the compressor is not normal. 4. correct method of adding fluorine Air conditioning fluoridation must be done slowly, with a little after the air conditioning running 10 minutes, and then measuring the pressure and current, but