网络文字摘录(国外英语资料).docVIP

网络文字摘录 News milling and end milling of milling machine One cycle milling Milling using the cutting edge on the periphery of the milling cutter is called circumferential milling, also known as peripheral milling. Since the cylindrical milling cutter is composed of a plurality of cutter teeth (blades), the milling plane can have tiny ripples. At the same time, its cylindricity influences the flatness of the milling plane directly. Two end milling The milling of the end teeth using end mills is called end milling, also known as end milling. It uses the tool point on the end face of the cutter to form a flat surface, so the machined surface also has a knife pattern. The roughness of the cutter is related to the speed, the N and the feed speed F. In addition, the verticality of the spindle axis and the feed direction of the milling machine determines the quality of the milling plane. Analysis and comparison of three weeks milling and end milling The milling and end milling are separate when milling a single plane, and the milling steps and grooves often exist simultaneously. As far as milling a single plane is concerned, the analysis of milling and end milling is as follows: 1 face milling cutter bar, clamping rigidity, knife work at the same time more, so the vibration; and the cylindrical cutter bar is longer, smaller shaft diameter, the cutter tooth while the work is relatively small, its easy to make the knife rod bending deformation caused by vibration. 2 face milling cutter is easy to insert carbide inserts for high speed milling, with high production efficiency and good milling quality, while it is difficult for cylindrical milling cutters to insert hard alloy inserts. The diameter of the 3 face milling cutter can be as large as 1m, and at one time, a wider surface can be milled; while the cylindrical milling cutter generally needs to be connected with the cutter when milling the workpiece with larger width, so there are 1 traces of the cutter. 4 cylindrical m