装载机传动系常见故障(国外英语资料).doc

装载机传动系常见故障 Common troubles of loader transmission system 2011-09-16 11:13 abnormal sound, parts quality substandard, the main transmission in assembly, installation and adjustment of improper, and the use of excessive wear and tear, will make loaders in driving and operation of abnormal sound. 1. common troubles of drive axle (1) the quality of the abnormal sound parts is not up to standard, the installation and adjustment of the main drive in the assembly is not proper, and the wear and tear in the use of the main drive will cause the loader to make abnormal noises during driving and operation. In general, abnormal sound increases with the increase of machine speed. Generally, there are several kinds of abnormal sound: The main and passive gear meshing gap is improper, making abnormal sound. The reason and phenomenon: if the active and passive gear meshing clearance is too large, causing the teeth of mutual impact, the sound is no rhythm thump, thump sound; if the meshing clearance is too small, the mutual extrusion between the teeth, the sound is continuous ow sound, and is accompanied by the driving axle heat; if engaged the gap is not uniform, the sound is the rhythm of the choking choking sound, serious when the drive axle will swing. Handling method: remove the main drive and readjust the meshing clearance between the main and the passive gears. Improper bearing clearance, abnormal sound. The reason and phenomenon: the bearing clearance is too small, the sound of melody...... Continuous sound; bearing clearance is too large, a messy funny, funny sound. Treatment method: remove the main drive, plus pad re adjust the bearing clearance; if the bearings have been damaged, should replace the new parts, then adjust the bearing clearance. Differential sound of differential mechanism. The reason and phenomenon are: planetary gear and the cross shaft card will be issued when the Ba GA, GA Ba sound, and in turn; planetary gear meshing bad sound complicated, when the ma