讲解挖掘机液压泵维修技能及改良方法(国外英语资料).docVIP

讲解挖掘机液压泵维修技巧及改进方法 When the excavator hydraulic pump is seriously worn, it has a fatal impact on excavator, so the excavator must be solved in time. Excavator hydraulic pump repair from the following three points to find the cause of the fault: (1) check the inner leakage of the boom cylinder The simplest method of maintenance of hydraulic pumps for excavators is to lift the boom to see if there is a distinct free fall. If the whereabouts of the obvious, then remove the cylinder inspection, sealing ring, if worn, should be replaced. (2) check the control valve First, clean the safety valve, check whether the valve is worn, such as wear should be replaced. After the installation of the safety valve, if there is no change, check the valve spool wear, the gap is generally used for 0.06MM, serious wear and tear should be replaced. (3) measure the pressure of the hydraulic pump If the pressure is low, then adjust, and the pressure is still not adjusted up, indicating that the hydraulic pump serious wear and tear. First, the main causes of the boom can not be improved: 1, excavator hydraulic pump serious wear and tear In low speed operation, the leakage of the pump is serious; when the pump is running at high speed, the pressure of the pump increases slightly; but because of the wear and tear of the pump, the volume efficiency decreases significantly, so it is difficult to achieve the rated pressure. Hydraulic pump for a long time, but also exacerbated the wear and tear, oil temperature rise, resulting in wear and tear of hydraulic components and seals of aging, damage, loss of sealing capacity, hydraulic oil deterioration, and finally lead to failure. 2, the selection of hydraulic components is unreasonable The movable cylinder is of 70 / 40 non-standard series, and the seal is nonstandard. The manufacturing cost is high and the seal replacement is inconvenient. Boom cylinder bore small, is bound to make the adjustment for high pressure system. 3 、 the hydraulic system d