连线机箱面板的旌旗灯号连线(国外英语资料).docVIP

连线机箱面板的信号连线 Connect the signal panel to the chassis panel 1. power switch The power switch is a signal to excite the ATX power supply to the main board and other equipment. The power switch on the panel panel is used to turn on / off the power supply (soft shutdown). Connect the power switch connection, first find the two pin plug marked Power SW from the chassis panel line, respectively is white brown two colors, and then plug in the motherboard is marked with the words PWR pin SW or PWR on it, do not need to pay attention to the positive and negative plug. 2. reset switch The reset switch is used to restart the computer. Connection reset switch connection, first find the two pin plug marked Reset SW from the chassis panel line, are white and blue two colors, and then on the motherboard pin marked with the words Reset or RST on it, do not need to pay attention to the positive and negative plug. 3. power indicator The power indicator indicates whether the current board is powered up. Connect the power light connection, first find the three pin plug marked Power LED from the chassis panel line, the middle line ends are vacant, white and green two colors, and then plug in the motherboard is marked with the words PWR pin LED or P LED. Since the power indicator is led, the connection is directional. Some motherboards will mark P LED+ and P LED-. We need to connect the green end to the P LED+ pin. The white line is attached to the P LED- pin. 4. hard disk indicator light The hard disk indicator indicates the working state of the hard disk. This light is blinking, indicating that the hard disk is accessing. Connect the hard disk light connection, first find the two pin plug marked H.D.D. LED from the chassis panel line, are red and white two colors, and then plug in the motherboard is marked with the words HDD pin LED or IDE LED. The connection of the hard disk indicator is also directional. Some motherboards will mark HDD LED+ and HDD LED-. We need to connect the red en