除尘器选型思量的因素(国外英语资料).docVIP

除尘器选型思量的因素 1, treatment of air volume (Q) sewage treatment equipment The amount of heat treated is the amount of air that can be purified by dust removal equipment in unit time. The unit is cubic meter per hour (m3/h) or cubic meter per hour (Nm3/h). It is one of the most important factors in the design of bag filter. Emulsion sewage treatment equipment According to the design or selection of air bag type dust collector, generally cannot make filter in high volume regulation environment, otherwise, the filter bag easy to plug, shorten the life span of the pressure loss increased substantially, the dust removal efficiency to low; but it cannot be selected volume is too large, or increase the equipment investment and floor area. Reasonable choice, punishment, air flow is often in accordance with the process, environment and shoes have always been chosen. Sewage treatment equipment 2. Utilization temperature For the bag filter, the temperature depends on two factors. The first is the maximum temperature of the filter material, and the second is the gas temperature, which must be above the dew point temperature. At present, due to the large selection of glass fiber filter material, the maximum utilization temperature can reach 280 DEG C, and the cooling method must be adopted for gases higher than this temperature, and the temperature reduction method must be adopted for the gas below the dew point temperature. At the moment with the PPS contest. Filter material at a temperature of 170 degrees. The bag type dust remover, the relationship of temperature and the dust removal efficiency is not obvious, the difference in ESP, esp, the temperature change will affect the dust resistance effect of dust removal efficiency. 3, import dust concentration That is to say, the concentration of imported dust, which is determined by the process of dusty spot, is another important factor after the design or selection of the bag filter. Use g/m3 or g/Nm3 to indicate. For a bag filter, t