参考计算书4.24.doc

泉州某地二级公路B段设计 中文摘要 本设计为东南沿海Ⅳ4区泉州某地二级公路B段设计，路线全长5241.692m。 该地区位于东南沿海，属山岭重丘区。本方案设计起点桩号K0+000，坐标为：X= 2792338，Y= 529412,与206省道相衔接；设计终点桩号为K5+241.692，坐标为：X= 2789708，Y= 533044。 道路平曲线设计有10个交点，最小半径为150m，最大半径为350m，其中设有一处S形曲线，两处同向曲线。竖曲线设有14个交点，最大纵坡为5.882%，最长坡长为510m。 路基横断面设计等腰梯形边沟和等腰梯形截水沟，填高大于6m时在路基边缘处设有0.8m高护栏。当填高大于8m时增设1m宽的护坡道，挖高大于6m时增设1m宽的碎落台。 全线设有两座混凝土简支梁桥(K0+180～K0+200，K3+180～K3+200)、12道涵洞，均为钢筋混凝土盖板涵、三处挡土墙，其中一处为衡重式路肩墙，两处仰斜式路堤墙。路面结构选用水泥混凝土路面，总厚度为58cm。 对K0+000～K3+000的三公里路线进行土石方的调配以及概预算文件的编制。路线的预算为1536.7万元，其中路面工程402万元，路基工程507万元，钢筋混凝土简支梁桥100万元，六处涵洞54万元。 关键词：平曲线,竖曲线,横断面,路基,路面 Design of paragraph B for a Secondary Road in Quanzhou Abstract The design aims to the zone B of a secondary roads which length is 5241.692m in the Quanzhou of the southeast coast Ⅳ4. The area is located in the southeast coast of China, authors of the mountains. The plan starting point, K0+ 000, coordinates for: X = 2792338, Y = 529412, connected and 206 provincial road; Design for pile end, K5 + 241.692, coordinate for: X = 2789708, Y = 533044。 There are 10 road flat curve intersections, the minimum radius is 150 m, maximum radius is 350 m, which have one S form curve, two homonymous curve. There are 14 vertical curve intersections, the largest HYPERLINK app:ds:longitudinal \t longitudinal HYPERLINK app:ds:slope \t slope is 5.882%, the longest slope length is 510m. Roadbed cross-sectional designs isosceles trapezoid ditches and isosceles trapezoid intercepting ditch, designing 0.8m high HYPERLINK app:ds:guardrail \t guardrail at the edge of the subgrade when roadbed is more than 6m tall When depth of fill is more than 8m,adding 1m wide slope protection way; when the dig deep height is more than 6m,adding 1m wide stage for heaping debris There are two sets of simply-supported reinforced concrete bridges(K0+180~K0+200, K3+180~K3+200), 12 road tunnels, are all reinforced concrete slabs, three place retaining walls, one place for balance weight retaining wall, two place for oblique earth-retaining wall