全自动空调系统培训.pptVIP

;SYSTEM SPECIFICATION;SYSTEM LOCATION;部件位置索引 ;REFRIGERANT CIRCUIT;CONDENSER;Release the high pressurized refrigerant and oil - Operating pressure: 35.3~42.2kg/?;THERMAL FUSE;3) 蒸汽泡的分离;TRIPLE SWITCH;TRIPLE SWITCH;TRIPLE SWITCH;电路示意图;FATC INPUT OUTPUT;HEATER UNIT;HEATER UNIT;HEATER UNIT;部件示意图 ;MAX A/C模式 ;A/C模式 ;仪表盘罩（中风口）模式 ;OFF ;仪表盘罩/底板（中风口/下风口）模式 ;底板（下风口）模式 ;底板/除霜（下风口/上风口）模式 ;除霜（上风口）模式;EVAPORATOR UNIT;EVAPORATOR AND BLOWER UNIT;EVAPORATOR AND BLOWER UNIT;EVAPORATOR AIR FILTER;EVAPORATOR AIR FILTER;BLOWER MOTOR ASSEMBLY;BLOWER SPEED CONTROL DEVICE;BLOWER SPEED CONTROL DEVICE;;;;INTAKE ACTUATOR;;MODE ACTUATOR;TEMP DOOR ACTUATOR;;FIN SENSOR;INCAR SENSOR;INCAR SENSOR;INSPECTION;PHOTO SENSOR;PHOTO SENSOR (FATC);AMBIENT SENSOR;AMBIENT SENSOR (FATC) ;AQS (FATC OPTION);AQS (FATC OPTION);AQS (FATC OPTION);HUMIDITY SENSOR (OPTION WITH AQS);HUMIDITY SENSOR (OPTION WITH AQS); 2. SPECIFICATIONS 1). Sensor type: High polymer impedance variation sensor 2). Rated voltage: DC 5V. 3). Current consumption: below 10 mA 4). Temperature range: 0 - 60 ℃ 5). Humidity range: below 99% RH(Relative Humidity) 6). Terminals: 3 terminals ( DC 5V, Ground, Sensor output)  3. Block Diagram;HUMIDITY SENSOR (OPTION WITH AQS);控制面板 (FATC, AQS);控制面板;TEMPERATURE UNIT CHANGE;CONTROL PANNEL SWITCH FUNCTION;CONTROL PANNEL SWITCH FUNCTION;CONTROL PANNEL SWITCH FUNCTION;1. 室内温度传感器修正 When the in-car sensor detects a sudden steep temperature change, controller corrects the temperature differences slowly. - 1℃ up / 4sec delay - 1℃ down / 4sec delay 2. 室外温度传感器修正 When the ambient sensor detects a sudden steep temperature change, controller corrects the temperature differences slowly. - 1℃ up / 3 min delay (ex. Underground, tunnel) - 1℃ down / 4sec delay;3. 热辐射修正 When the photo sensor detects a sudden steep solar radiation change, controller compensates it slowly. - 350 → 1000 (W/m2) / 1 min delay - 350 ← 1000 (W/m2) / 5 min delay 4. 温度门控制 Temp. door angle (0% ~