EDS-T-4302：1999 DURABILITY TEST OF ASSIST GRIP.pdf

EDS Engineering, Daewoo motor co., ltd. Standards DURABILITY TEST OF ASSIST GRIP EDS-T-4302 ISSUED DATE: 1995. 09. 25 REVISED DATE: 2001. 05. 14 VERSION: 3 PUBLISHED BY ENGINEERING STANDARD SECRETARIAT TECHNICAL CENTER(PUPYONG) DAEWOO MOTOR CO., LTD. EDS-T-4302 어시스트 그립 내구시험절차 PAGE: 1/4 1. Purpose This standard is an extension of designing activities and defines the general test conditions regarding Assist Grip durability and strength. 2. Scope The standard is applied to assist grip to be fixed onto all kinds of vehicles (sedans, multi-purpose passenger cars, etc) that are produced in Daewoo 3. Testing Equipment 3.1. Fixed Jig 3.2. Pneumatic Cylinder Control Box 3.3. U.T.M (UNIVERSAL TEST MACHINE) 4. Test Piece Preparation (1) If the test piece is different from the one that has been approved or needs design modification so that it is deviated from the standard specifications, the test piece supplier must notify it to the person in charge of the testing. (2) The supplier must check data on dimensions measurement and send it to the user. If there is any slight difference, the supplier must notify it of the user. (3) Unless otherwise specified, keep the test piece at the standard temperature and humidity (20±5℃, 65±20%) and then perform a test on it. Maintain the tightening torque as indicated in the drawing. 5. Testing Methods and Requirements Assist grip has three types as shown in Figure 1. SLIDING TYP