208硬母线安装施工工艺(国外英语资料).doc

208硬母线安装施工工艺(国外英语资料) 1 scope This technology standard is suitable for the following moment type bus installation in 10kV. 3 operation process 3.1 process flow: The installation of the line measuring, the mounting of the brackets and the tightening device, the installation of the insulator, the processing of the bus, the connection of the bus line The bus line is installed as well as the bus line painting brush oil to check the electricity 3.2 line measurements: After entering the scene, according to the different condition of the bus and the lining of the frame, the check is consistent with the drawing. 3.2.2 alignment measurements: check the length along the bus bar installation direction without obstacles, to building structures or equipment pipeline crossover phenomenon, such as ventilation installation components. 3.2.3 distribution cabinet to install the bus to measure the safety distance of other parts of the equipment. Measuring the size and the size of the frame of each section, and the distance of the brackets and the position of the fixed parts. The installation of 3.3 brackets and tensioning equipment The 3.3.1 bus holder is made of 50x 50x5 Angle steel. The expansion bolts are fixed to the wall (figure 2-37). The 3.3.2 bus tightening device is assembled in the attached drawings (figure 2-38). 3.4 insulator installation: Before the installation of an insulator, the insulation must be waved, and the resistance value of the insulation will be greater than 1 megaohm. Check the appearance of the insulator for the non-crack, the defect, the bolts of the insulator and the nut is strong and the back can be used. Pressure test should be done before the installation of the 6 ~ 10kV pillar insulator. Figure 2-37 Figure 2-38 The 3.4.2 insulator is cushioned by an asbestos pad. The specification of the 3.4.3 insulator plywood and card board should be adjusted to the specification of the bus line. The installation of insulator plywood and card board is firm. 3.5 bus p