ADSL 猫常见故障与修复(国外英语资料).doc

ADSL 猫常见故障与修复(国外英语资料) Fame is the best of all. Park in love maple, red in February. The eyes are full of laughter and the six paladins are colorless. The road is not covered by the thread, but the spring and spring are black and yellow. The spring silkworm comes to death, the wax is dry and dry. Common failures and solutions for ADSL cats The trouble 1 indicator is not bright Maintenance method: replace the 34063 chip and replace the DBS104G rectifier bridge Reason: the power chip is damaged The fault 2 indicator is all bright Maintenance method: replace the AT45DB161B chip and re-write the software Reason: Flash chip damage The fault 3 Lan lamp is not bright, cant ping through 192.168.1.1 Maintenance method: replace the RTL8201BL chip Reason: the networks chip was struck by lightning Fault 4 is often dropped Maintenance: check the software version number and upgrade if the version is too low Why: the version is too old and the old version is inherently flawed The fault 5 Lan indicator is normal, cant ping to 192.168.1.1, cant do the web management Maintenance method: the Modem default parameter is modified to restore the default value of the factory Reason: the parameters are modified Failure 6 only power lights, other lamps are not bright, and turn on not self-examination Maintenance method: the device is not started, and the software is reprogrammed in the Flash chip Reason: software damage One, there are several power test points in MODEM maintenance, so be sure to understand The main chips power supply voltage should be 1.8 volts The networks chip and FLASE, the power supply voltage of the SDREM is 3.3 volts Count the power supply voltage of the conversion chip 5.3 volts Second, ADSL MODEM maintenance common failure Note: the main cause of the failure of the following statement does not contain the external factors, such as: circuit, noise, electromagnetic interference, the operating system, network CARDS, dial-up software, etc. This is mainly due to the failu