cmos设置(国外英语资料).docVIP

cmos设置(国外英语资料) BIOS Settings, [Standard CMOS Setup] In this menu, the user can modify the date, time, the first main IDE device (hard disk) and IDE devices (hard disk or cd-rom), the second main IDE devices (hard disk or cd-rom), and from the IDE device (hard disk or cd-rom), floppy drive A and B, the type of display system, any error condition to lead to suspension system startup, etc. The main instructions are as follows: (1) the user can be set to Auto in Type (Type) and Mode (Mode), so that the BIOS automatically detects the hard disk. You can also set it up in the main menu (IDE HDD Auto Detection). Users can also use the User option to manually set the parameters of the hard disk. You must enter the number of cylinders (Cyls), head count (Heads), writing precompensation (Precomp), head landing zone (Landz), each cylinder sectors (Sectorxs), work Mode (Mode, see below) and so on several parameters. The size of the hard drive is automatically generated after the parameters are set. Three options for the hard drive MODE (MODE) : NORMAL mode: traditional standard mode that supports hard disk capacity up to 528MB. LARGE mode: this option is available when the hard disk or operating system does not support the LBA mode when the hard disk capacity exceeds 528MB. Logical Block Addressing Mode: applied to the hard disk capacity over 528M and supports the Logical Block address (LBA) function (which is commonly used) (2) optional EGA/VGA display type (EGA, VGA, SEGA, SVGA, PGA display adapter card is chosen), CGA40 (CGA display card, 40), CGA80 (CGA display card, 80), MONO (monochrome display mode, including high resolution graphics) of four kinds of, the user should be selected according to situation right. (3) the pending error status options are: AllErrors: the BIOS detects any errors and the system startup stops and gives an error message. NoErrors: the BIOS detects that any error does not cause the system to start a pause. All, But Keyboard: in addition to the Keybo