DS18B20自动搜索ROM51C程序多点测温经验证(国外英语资料).docVIP

DS18B20自动搜索ROM51C程序多点测温经验证(国外英语资料) # include reg52. H # include intrins. H # define uchar unsigned char / / define unsigned single byte # define uint unsigned int / / define unsigned plastic surgery # define MAXNUM 2 / / defines the maximum number of DS18B20 that is not displayed P1 sbit DQ = ^ 3; / / define the data line Sbit RS = P2 ^ 4; Sbit RW = P2 ^ 5; Sbit E = P2 ^ 6; Uchar code lcd0 [] = { SEARCH ROMING... }; Uchar code lcd1 [] = { SEARCH ROM OK! }; Uchar code lcd2 [] = { The total is: Uchar code lcd3 [] = { No. Uchar code lcd4 [] = { 0 , 1, 2, 3, 4, 5, 6, 7, 8, 9, , , , , , , , , , , , , , , , , , , Uchar dat [6]. Uchar temp_l, temp_h, is_fuwen, temp_x, temp_over, t; Uchar num = 0; Uint I; Uchar al [MAXNUM]; Idata uchar ID [MAXNUM] [8]; / / = {0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, 0, Void alarm_search (void); / * * * * * * * * * * * * * * * * * * * * * * * LCD module * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * * / Void delay () / / delay program { Uchar y; For (y = 0; y 250; y + +); } Void lcd_write_write_com (uchar com) / / write { Delay (); RS = 0; RW = 0; E = 0; E = 1; P0 = com; E = 0; Delay (); } Void LCD_write_data (uchar dat) { Delay (); RS = 1; RW = 0; E = 0; E = 1; P0 = dat; E = 0; Delay (); } Void init () / / initialization { LCD_write_com (0 x01); X38 LCD_write_com (0); X0c LCD_write_com (0); LCD_write_com x06 (0); } / * * * * * * * * * * * * * * * * * * * * * * * * ds18b20 * * * * * * * * * * * * * * * * * * * * * * * * * * * * / Void delay_nus (uint n) / / delay program 8 + 6 (in and out) = 14us { While (n -); } Void reset (void) / / ds18b20 initializes the reset operation { Unsigned char x = 0; DQ = 1; / / DQ reset Delay_nus (8); / / slightly delay DQ = 0; / / the chip machine will lower DQ Delay_nus (80); / / exact delay is greater than 480us DQ = 1; / / pull up bus Delay_nus (10); X = DQ; / / slightly delayed if x = 0 initializes success x