porteus的快捷键和元件名(国外英语资料).doc

porteus的快捷键和元件名(国外英语资料) TRAFFIC towns 7 seg - mpx2 - cc/ca The BUTTON LGM12641BS1R F8: full display of the current workspace F6: zoom in at the center of the mouse F7: zoom out in the center of the mouse G: grid switch grid grid Ctrl + F1: the grid width 0.1 mm shows a grid of 0.1 mm, which is useful in PCB F2: the grid is 0.5 mm with a grid of 0.5 mm, which is useful in PCB F3: the grid is 1mm for 1mm and is useful for PCB F4: grid 2.5 mm shows the grid 2.5 mm, which is useful in PCB Ctrl + s: turn off the magnetosuction to be used for pointing at points, such as pins, etc X: turn off the closed location coordinates to display a large cross ray M: the unit switch between mm and th is shown in the lower right corner O: reset the origin to the point where the mouse points to the origin U: key revocation Pgdn: change the layer Pgup: change the layer Ctrl + Pgdn: bottom Ctrl + pgup: at the top Ctrl + line: you can draw a curve R: refresh + - : rotating F5: relocation center The Proteus element name is 1 Description of the name of the element 7407 driver gate 1N914 diode 74Ls00 and non-gate 74LS04 is not a door 74LS08 and the door 74LS390 TTL double decimal counter 7SEG 4 pin bcd-led output from 0-9 to the BCD code of the four lines 7SEG 3-8 decoder circuit bcd-7seg [size = + 0] The ALTERNATOR ALTERNATOR The AMMETER MILLI - mA AMMETER AND gate BATTERY BATTERY/BATTERY pack BUS BUS CAP capacity CAPACITOR CAPACITOR CLOCK signal source CRYSTAL vibration D - FLIPFLOP D flip-flop FUSE FUSE GROUND GROUND LAMP LAMP LED - RED light emitting diode LM016L 2 lines 16 LCD display 2 lines 16 characters in English, there are 8 bits of data bus D0 - D7, RS, R/W, EN three control port (14), the voltage is 5 v. No backlight, and the commonly used 1602B function is the same as the foot (except for the two lines of the backlit). The LOGIC ANALYSER logical analyzer LOGICPROBE logic probe The LOGICPROBE [BIG] logic probe is used to display the logical state of the connection position LOGICST